|
Got it installed and it worked great! Only issue was that they didn't run a pin for the "illumination" wire. So I just cut that wire and splice directly into it but left enough so I could reconnect it if I wanted to return it to stock. Price was about $28 I think. If you want to salvage the stock wiring harness from the stock stereo, here is the pin layout as you are looking at the pin side.
7-6-5 space 4-3-2-1
15-14 space 13-12-11-10 space 9-8
1-Amp Turn On
2-Illumination
3-Accessory
4-Constant 12V
5-Mute (not used)
6-Left Front Amp input (+)
7-Right Front Amp input (+)
8-Power Ant.
9-Not Used
10-Telephone Mute (not used)
11-Ground (Ground here or on chassis)
12-Signal Ground (- for all speaker amp inputs)
13-Beep (not used)
14-Left Rear Amp input (+)
15-Right Rear Amp input (+)
Directions are basically the same as above, except with this configuration. Good luck!
Greg
|