I know this is an unusual question . I may be able to get hold of a red top beams engine . However, it doesn't have the coil packs or ecu etc.
I would be planning to disable the vvti and fit aftermarket cams from my rev 4 3sge, and was wondering wether I could basically swap in my dissy and set this up to run on my current ecu, then adjust the fuelling via an apexi safc2 ?
Basically I'm looking at using the engine for the raised compression, improved intake plenum and lower mileage . I then plan to mount the Throttle body from a 3litre camry and port the intake to allow better top end breathing .
Any help is much appreciated .
(I realise I could just mate my rev 4 3sge head to the block, but why split a perfectly good headgasket
)