Quote:
Originally Posted by WFX
If I was to design a 2-1 piece to fit the header how do I know the length of the 2 piece before it goes into 1 piece? Do I make it the same length as the stock piece or try and get some photos/measurements of the Phoenix 2-1 piece?
doggyDCW: To my door in Perth, Australia via EMS (within 1 week shipping) it was $1100 AUD including customs tax!
I shall have photos and specs for everyone up here when it arrives!  |
have someone mandrel-bend you two pieces of pipe that run from the header to the flex-pipe and then halve them at the tips (around 8 inches out) where they would meet up with the flex-pipe, weld the halved tips together and run them into the flex-pipe flange....do install a resonator from Vibrant
http://vibrantperformance.com/catalo...3fe3828a901ac8
somewhere past the flex-pipe...
you will flow ALOT more so you will need some back-pressure if you dont wanna loose all your bottom end grunt!