View Single Post
Old 07-07-2007, 10:18 AM   #8 (permalink)
Weasy2k
3.4L 10K RPM In the works
 
Weasy2k's Avatar
 
Join Date: Mar 2005
Location: Vancouver, BC
Posts: 8,928
Thanks: 34
Thanked 76 Times in 65 Posts





Send a message via AIM to Weasy2k Send a message via MSN to Weasy2k
There have been no real dynogrpahs to prove any huge power vehicles...i have yet to see one of anything over 500whp....I have several customers who are in the works to build big motors but nothing completed...so its only a matter of time before we start to see some good numbers show up!

LB
1500-16.123630008
2000-12.05285906
2500-17.14894118
3000-24.74446411
3500-33.72856528
4000-48.54469503
4500-62.11110436
5000-69.01233818
5500-75.913572
6000-82.81480582
6500-89.71603963
7000-96.61727345

This with full boost of 35psi at 4500rpm ish (just a relaly rough estimation) and 100% VE (rare but you can just take off between 15-20% on some cells to give a more conservative figure.)



3.38 is the PR of 35psi....

as you can see its not even on the map....that pressure ratio sucks for that turbo!


This would work
__________________
-Johnny @ Sea2Sky Tuning - www.sea2skytuning.com
V6 Motor mounts discontinued, until further notice.
Founder of the V6 Engine Stand Club...Join Today! (Or perhaps you are one of those "cool" guys who wants to put his v6 in the car instead. )
Weasy2k is offline   Reply With Quote
 
Page generated in 0.17351 seconds with 18 queries