timing belt silvertop

espguitarist33 · 09-27-2009, 06:47 PM

when you time a silvertop....how do you go about applying tension to the pully? do you just let the loose and after the spring goes tighten it?

chrisclose · 10-03-2009, 09:29 PM

thats how i did it

espguitarist33 · 10-03-2009, 11:07 PM

yea i figured out my problem...the plates that goes against the crank gear was backwards and chewed up the belt

espguitarist33 · 10-10-2009, 02:30 PM

The T081 timing belt has too many teeth so wherever the crossreference came from...its not right..that blet has like 117 teeth or so

09-27-2009, 06:47 PM	#1 (permalink)
espguitarist33 Cage Fighter Join Date: Nov 2008 Location: west chester PA Posts: 415 Thanks: 4 Thanked 5 Times in 5 Posts iTrader Rating: (2/100% )	timing belt silvertop when you time a silvertop....how do you go about applying tension to the pully? do you just let the loose and after the spring goes tighten it?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

10-03-2009, 09:29 PM	#2 (permalink)
chrisclose Cage Fighter Join Date: Dec 2006 Location: tulsa OK Posts: 125 Thanks: 3 Thanked 1 Time in 1 Post iTrader Rating: (2/100% )	thats how i did it

10-03-2009, 11:07 PM	#3 (permalink)
espguitarist33 Cage Fighter Join Date: Nov 2008 Location: west chester PA Posts: 415 Thanks: 4 Thanked 5 Times in 5 Posts iTrader Rating: (2/100% )	yea i figured out my problem...the plates that goes against the crank gear was backwards and chewed up the belt

10-10-2009, 02:30 PM	#4 (permalink)
espguitarist33 Cage Fighter Join Date: Nov 2008 Location: west chester PA Posts: 415 Thanks: 4 Thanked 5 Times in 5 Posts iTrader Rating: (2/100% )	The T081 timing belt has too many teeth so wherever the crossreference came from...its not right..that blet has like 117 teeth or so