Thread: 3S-GTE USDM Turbo Engine ssautochrome t3/t4 any good?
View Single Post
Old 04-14-2008, 07:10 PM   #48 (permalink)
Bak@EMSPowered
Banned Seller
 
Join Date: Oct 2005
Location: Austin, TX
Posts: 5,925
Thanks: 30
Thanked 193 Times in 165 Posts

My Google Map



Send a message via AIM to Bak@EMSPowered Send a message via MSN to Bak@EMSPowered Send a message via Yahoo to Bak@EMSPowered Send a message via Skype™ to Bak@EMSPowered
I think you guys are mistaking "research" for ignorance. Your research is just basically the combination of IGNORING the advice, research, experience, and proof that others have done and posted about in the hopes that you may have somehow found the fountain of youth while others have been wrong. This is not the case guys. These parts have been proven time and time again to be inferior, poorly built, GLUED together in some cases, poorly designed and WILL cause damage to your motor when they break.

Nobody is flaming you here, but the ignorance and blatant blindness of your ways (and many others like you before you were here) is what gets people flamed and ridiculed.

What happens next? One of the following:

* you look at the stuff, laugh and move on

* you take the advice of people who have been there and done that and stop chasing a fools dream

* you take the plunge, order the parts. You either get lucky and get the kit for the right car or get unlucky and get the kit for the WRONG CAR, as which is the case many times with these cheap knockoff kits. Then you install the stuff, it either fits or doesn't fit. Lets just say it fits. Then you are disappointed when your car is slower than it was before, then eventually a piece of the compressor wheel goes flying through your motor and you end up having to spend several thousand dollars rebuilding your motor. In 99.999% of these cases the owner is usually too much of a panzy to fess up and come back on here and share his story.

So anyway, good luck with your modifications.
Bak@EMSPowered is offline   Reply With Quote
The Following 4 Users Say Thank You to Bak@EMSPowered For This Useful Post:
eckoman_pdx (04-16-2008), mr2magic (04-15-2008), p3c0r (09-24-2009), shimric (04-14-2008)
 
Page generated in 0.15481 seconds with 16 queries