[HarrisRacing]

I read the post here regarding the rear subframe differences and I am going to modify my 1991 racecar's subframe to replicate the 1993 geometry while the engine is out of the car.

can anyone verify the placement that was previously suggested?:

Rear toe links = 1993 is 3.75" longer than 1991
Fasten point on subframe:
Vertical placement = 1993 is 4mm higher (vertical) than 1991
Horizontal = to make up difference between the two (will calculate).

So I need someone to put a tape measure on it for me and perhaps take some pictures.

Reason I want to make this change = save some Toe-in on the rear to save tires...also make correctability better which will make it easier / safer for me to pass in the corners (not that mine is THAT bad with the toe-in that I run...just want it better at zero toe in).

Thanks,
Patrick Harris