Toyota MR2 Message Board - View Single Post - 20V MK1 Engine Swap Flywheel and pressure plate question.

MosquitoXR13 · 08-17-2008, 03:19 AM

I bought an XTD lightweight flywheel off of ebay for my 20V swap and the pressure plate that came with the clutch assembly I bought before I started the swap is too small to fit on the mounting studs of the flywheel. The flywheel is labeled as being for an 85 to 89 Toyota Corolla. The clutch I bought is a Zoom Performance, Stage 2, 4 puck clutch, I only need to replace the pressure plate but am confused as to how I am supposed to figure out what pressure plate I need. Has anybody else purchased this flywheel and if so, what pressure plate will work??

08-17-2008, 03:19 AM	#1 (permalink)
MosquitoXR13 AW11 Noobie Join Date: Jun 2006 Location: Rochester, NY Posts: 158 Thanks: 2 Thanked 0 Times in 0 Posts iTrader Rating: (0/0% )	Flywheel and pressure plate question. I bought an XTD lightweight flywheel off of ebay for my 20V swap and the pressure plate that came with the clutch assembly I bought before I started the swap is too small to fit on the mounting studs of the flywheel. The flywheel is labeled as being for an 85 to 89 Toyota Corolla. The clutch I bought is a Zoom Performance, Stage 2, 4 puck clutch, I only need to replace the pressure plate but am confused as to how I am supposed to figure out what pressure plate I need. Has anybody else purchased this flywheel and if so, what pressure plate will work??