|
I'll have a look for it when i'm at home.
If your set on using a blacktop beams then you will need to modify the block around the rear engine mount. It has two extra holes here that are not present on the turbo block, this is to make way for the transfer case, so will need ground off.
You will need to use a redtop sump and water outlet, and inlet manifold
Also the engine mount at the timing belt side will interfere with the vvti controller on the exhuast side of the engine so you'd need a custom mount there.
As for Toda i cant say, Celica_ra45 uses there parts and modify's them and he wasnt that kind about there consistency. I would buy any parts through him he can supply forged pistons etc
I think this would be a very expensive and complex project so i hope you have LOADS of money.
|