Toyota MR2 Message Board - View Single Post

MANDALAY · 01-01-2009, 06:47 AM

Can you help with this.
Water temperature senor for the EFI is located in the water outlet housing . TRUE ?
I remember buying as its on the EPC water temperature sender where is that one located and is that for the instrument cluster gauge ?
Oil pressure switch , where is that located ?
Also another sensor on the block near the knock sensor looks like a big transister ? What is it.
That side of the harness has the following connectors
1. Alternator
2. Positive alternator
3. 2 earth wires
4. Knock sensor ( that screws into the block ? )
5. O2 sensor
6. ? Mister transister ??????
Also on the turbo last gen they use a air filter befor the MAP, i bought it also , so should i use it.
As you can gather im writting a list of all the things i would like the Motec to control and or trgger.
Any thoughts are greatly appreciated.
List
air inlet temp
Engine water temp
MAP
Rotrex oil temp
Water pump fo IC
Water temp of IC coolant
Fan for Rotrex oil cooler.
Last question for now.
The car has a fan in the side.Thats where im going to put my oil cooler with its fan for the Rotrex oil. The Motec will monitor the temp and turn on the fan accordingly. Can i parrallel the wiring for the comparment fan to this fan so when the comparment reaches 62 dgrees as per the manual this same fan comes on ?
Even if the oil is not hot i dont mind the fan to go on as Rotrex recommends the colder the better as the oil is used for traction not cooling and if the temp is too high pop goes the Rotrex.

01-01-2009, 06:47 AM	#284 (permalink)
MANDALAY Beams Owners Group Join Date: Feb 2007 Location: victoria AUSTRALIA Posts: 4,209 Thanks: 136 Thanked 112 Times in 107 Posts My Google Map iTrader Rating: (6/100% )	Can you help with this. Water temperature senor for the EFI is located in the water outlet housing . TRUE ? I remember buying as its on the EPC water temperature sender where is that one located and is that for the instrument cluster gauge ? Oil pressure switch , where is that located ? Also another sensor on the block near the knock sensor looks like a big transister ? What is it. That side of the harness has the following connectors 1. Alternator 2. Positive alternator 3. 2 earth wires 4. Knock sensor ( that screws into the block ? ) 5. O2 sensor 6. ? Mister transister ?????? Also on the turbo last gen they use a air filter befor the MAP, i bought it also , so should i use it. As you can gather im writting a list of all the things i would like the Motec to control and or trgger. Any thoughts are greatly appreciated. List air inlet temp Engine water temp MAP Rotrex oil temp Water pump fo IC Water temp of IC coolant Fan for Rotrex oil cooler. Last question for now. The car has a fan in the side.Thats where im going to put my oil cooler with its fan for the Rotrex oil. The Motec will monitor the temp and turn on the fan accordingly. Can i parrallel the wiring for the comparment fan to this fan so when the comparment reaches 62 dgrees as per the manual this same fan comes on ? Even if the oil is not hot i dont mind the fan to go on as Rotrex recommends the colder the better as the oil is used for traction not cooling and if the temp is too high pop goes the Rotrex. Last edited by MANDALAY; 01-01-2009 at 06:55 AM..