Here is the first batch of pictures I don't have the parts for the turbo oil feed but this will get anyone started (masagsxr i belive you mentioned wanting to try this in another thread)
First up is the Oil cooler.. I had to twist it a little bit from it's origin.. I'm not sure about this quite yet as I haven't been able to test oil feed since I didn't have a pump to throw on ..
I bought the barbed fitting at home depot.. It is actually pretty sweet.. It has barbed ends which make it impossible to pull the darn hose back out.. and it even did the size conversion I needed..
You can see the stainless braided line I used and the hfh heat insulation claped back on .. That should be able to handle all the heat You can throw at it
Here is the cutout of the heat shield for the oil filter... the down pipe was then painted with high temp paint to help the heat not radiate to the darn filter
here is the start of the oil feed for the turbo .. I cut the part that bolted to the 3s block in favor of a flange fittign to be named lata
Again you can see the insulation on the HFH
This is the presssure sender on the head which I plan to T off of
