Toyota MR2 Message Board - View Single Post

smacker · 06-06-2009, 01:01 AM

So i finally went for dyno couple of days ago, 196hp/200 torque but the car is running rich at 15psi. i'll post my results...

the only mod is fujitsubo exhaust. i'm thinking intake and boost controller next but probaby need a full engine managment system.
i've read that 93 and up gen3 jdm's are programmed for fail safe mode over 16psi. I thought stock ct20 was 13psi but mine is at 15.

i've heard of cheap ways to push the fail safe to 18psi. i'm looking for recommendations for intake (Apexi power intake?), boost controller and options for fuel/engine management since this can vary from a few hundred to thousands.

06-06-2009, 01:01 AM	#1 (permalink)
smacker No Skills Join Date: May 2009 Posts: 9 Thanks: 0 Thanked 0 Times in 0 Posts iTrader Rating: (0/0% )	upgrade suggestions for 3sgte So i finally went for dyno couple of days ago, 196hp/200 torque but the car is running rich at 15psi. i'll post my results... the only mod is fujitsubo exhaust. i'm thinking intake and boost controller next but probaby need a full engine managment system. i've read that 93 and up gen3 jdm's are programmed for fail safe mode over 16psi. I thought stock ct20 was 13psi but mine is at 15. i've heard of cheap ways to push the fail safe to 18psi. i'm looking for recommendations for intake (Apexi power intake?), boost controller and options for fuel/engine management since this can vary from a few hundred to thousands.