Thread: 3S-GTE USDM Turbo Engine Blitz nurspec or Berk Technology?
View Single Post
Old 07-17-2009, 01:17 PM   #26 (permalink)
Sang
Turtle
 
Sang's Avatar
 
Join Date: Jul 2006
Location: FL
Posts: 4,096
Thanks: 18
Thanked 267 Times in 246 Posts





Quote:
Originally Posted by Basement Digital View Post
Blitz.
...
I believe it's the lightest MR2 component exhaust kit too.
Not by a long shot. It's lighter than duals, but it's heavier than most singles.

Quote:
Originally Posted by doom26464
no its still a total of 6 inch becauses exhaust travels through both pipes. in turbo world bigger is always better as well. hands down dual systems wethere its ems, berks, deperature 2 etc. will out flow single setups liek apexi n1 and blitz. most people buy the single system becauses they like the look,sound etc. the only major advanatages are singles usually are a tad lighter.
All that test showed was that one flowed more, which is obvious from shear cross-sectional area. But if the single is not a restriction, then a dual isn't going to make more power. Had that test controlled boost pressure, then the two would had the same power output.

3" TKO vs. 3" R1 has shown to provide the exact same amount of power up to the 370whp level.
Sang is offline   Reply With Quote
 
Page generated in 0.32653 seconds with 16 queries