Quote:
Originally Posted by tstoney82
ive also heard that you can use black silicon gasket maker. from what i understand, all you do is apply the gasket maker to the t-top seal, then rub a small amount of vasaline on the body side where the gasket meets (this will keep the gasket maker from sticking to the body side seals)put the tops on and let it sit for about 30-45 minutes. after it dries, take the tops off and wipe off the vasaline and it should seal. i havent tested this yet, but ive heard of people doing it on 2's and some 300zx's around here and they said it works. i'll give it a shot and post the results.
|
I kinda did this after mine started leaking, long story short I had gasket sealer and it was raining so I did it and in the process discovered the PO had used bluetak to seal the tops (it had gone black). So far so good it doesn't leak anymore, too bad I only had dark green sealer it looks a little funky
