Thread: For Sale: 87 toyota mr2 20v ttop
View Single Post
Old 08-15-2009, 02:44 PM   #1 (permalink)
David8Lt
No Skills
 
Join Date: Jun 2007
Posts: 17
Thanks: 0
Thanked 0 Times in 0 Posts





87 toyota mr2 20v ttop
Vehicle Location: Silver Spring, MD
Vehicle Price: 2300
Vehicle Odometer: 166000

OK im going to try to sell my mr2 again. i posted it up a few months ago, but it had several problems that i fixed.

This is a 1987 toyota mr2 ttop. It has about 166k on the chassis. It has a strong 4age 20v silver top. The motor does not smoke, tick, knock, or any of that. The transmission does not grind pop out of gear. The clutch does not slip. I do not know when the last clutch change was, but its still strong. I changed the oil w quaker Q 10w30 or 10w20 every 3k or less. I replaced the master break, break booster, 2 calipers about 9k ago. It has a clean title. I have a carfax report on it too. vin # JT2AW15J3H0119384

I personally have owned this car for about 10k miles of its life. iv driven it everywhere, its my daily driver. iv taken it on 9h road trips without any problems. I also have most of the ac parts in. i just need to install the belt, run it to a switch, and charge it up. i did some rust prevention as seen in the photos. i cut out the rust, welded a plate to it, and foamed the inside of it up. i did it to both sides. i did this to prevent the rust and make the car stiffer. i also plugged up some line, so it doesn't seem to leak gas anymore! the gas light is always on, the gauge works that light just says on.

good
-strong motor
-4age 20v, so its probably low miles.
-aftermarket antenna
-good interior
-comes w some aftermarket parts
-reliable
-Heat works
-radio works, has aftermarket speakers in the front
-american racing rims w about 50% tread on them

bad
- feels like blown struts
- i cut out the front sway bar. (its not a bad thing, i was going to get stiffer spring to compensate.)
- got rust
-passager door is manual and blue. but i have the old door and interior if u want it.
-ttop leaks, seals just needs to be replaced.
-front bumper is basically zip tied on

some aftermarket parts
-87 front calipers (they sell for about 100-150 on the market).
- front drilled rotors
-steel braided lines

asking 2,300$ im fairly firm, but im willing to negotiate. i will look into trade. i hate on FWD cars, i hate on civics. im not trying to part it out. email for more pic or questions, i dont really answer to PM's here. located in Silver Spring, MD
dkpbws2001@yahoo.com

-David











David8Lt is offline   Reply With Quote
 
Page generated in 0.14417 seconds with 18 queries