Toyota MR2 Message Board - View Single Post

ZIELINSKI · 08-23-2009, 03:10 AM

I hosed my MK1 engine down, TOok the leads off to shove rag so the plugs dont flood with water.. All went well,

Then i put the leads back on.. And it doesnt go.. I cleared the little bit of water that was there out, put some WD40 and attacted the leads.. Now all it does is bang and miss and wont even turn over.

Iam pretty sure i may have put 3-4 on the wrong spark plug, tryed it, then swapped it back.

Still no go, I took out the plugs, they look fine. But i seriously have no idea.. Iam s00o0o stressed please helppp..

PLEASEEE Any ideasssss

08-23-2009, 03:10 AM	#1 (permalink)
ZIELINSKI Ready to Learn Join Date: Apr 2007 Location: NSW, Australia Posts: 198 Thanks: 3 Thanked 3 Times in 3 Posts iTrader Rating: (0/0% )	PLEASE ANYONE HELP!!! :( I hosed my MK1 engine down, TOok the leads off to shove rag so the plugs dont flood with water.. All went well, Then i put the leads back on.. And it doesnt go.. I cleared the little bit of water that was there out, put some WD40 and attacted the leads.. Now all it does is bang and miss and wont even turn over. Iam pretty sure i may have put 3-4 on the wrong spark plug, tryed it, then swapped it back. Still no go, I took out the plugs, they look fine. But i seriously have no idea.. Iam s00o0o stressed please helppp.. PLEASEEE Any ideasssss