[IDon'tKnow]

I'll take a closer look at the harness tomorrow. The tricky thing about figuring which wire to tap into is that the wire running to the door switch is red with a black stripe, and the wires running into the dome light are red and red with a white stripe.

Edit: yea, the plug I'm referring to is under the carpet right up against the rear bulkhead. The lines coming off of the door switches have a lot of slack in them that is taped up to the routing tab that secures the harness (sub).... I'm not sure what is going on at that juncture. Come to think of it, I don't think it matters if you tap the r or rw line to/from the dome light. Maybee you could just let that slack out and add a little extra length.

I would feel like I cheated myself if I went through all the trouble of setting that up and then put it on a manual switch. I'm a wiring noob and I'm learning as I go. I can't imagine that getting it to function with the dome light switch will be difficult.... It's a two wire plug up there.

I'll get my electrical engineering buddy on the phone tomorrow