jump starting

Mr2civic817 · 11-28-2009, 12:20 PM

Happy thanks giving guys,

Last time I was up there, my battery died, and I watch Aarom jump started, my MR-2 from the engine bay.

I know this is a dumb question, but I got to much junk in my frunk. Takes me 30 min on a good day to take everything apartjump start then put everything back. Thats not even including the ATS Brake Master cylinder brace I got from yall.

Where do you attach the + and - in the engine bay to jump start it

CJMR2T · 11-28-2009, 12:40 PM

Attach the Negitive (-) to any metal bracket (like engine lifting hook) on the engine. Connect the Positive (+) to the bolt stud on the starter where the heavy battery cable is connected.

Note, make sure that the positive (+) is not touching anything metal besides the stud sticking out of the starter...

ATSAaron · 11-29-2009, 10:06 AM

Thanks. That is the correct answer. I have also used the two 10mm studs in the rear fuse box for charging, but not for jump starting.

Aaron

Mr2civic817 · 01-17-2010, 01:30 AM

thanks alot guys, I needed this helpful tip

11-28-2009, 12:20 PM	#1 (permalink)
Mr2civic817 Cage Fighter Join Date: Oct 2006 Location: Arlington Tx Posts: 189 Thanks: 11 Thanked 3 Times in 3 Posts iTrader Rating: (3/100% )	jump starting Happy thanks giving guys, Last time I was up there, my battery died, and I watch Aarom jump started, my MR-2 from the engine bay. I know this is a dumb question, but I got to much junk in my frunk. Takes me 30 min on a good day to take everything apartjump start then put everything back. Thats not even including the ATS Brake Master cylinder brace I got from yall. Where do you attach the + and - in the engine bay to jump start it

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

11-28-2009, 12:40 PM	#2 (permalink)
CJMR2T Fabricator Join Date: Oct 2009 Location: Lakeland, FL Posts: 3,688 Thanks: 3 Thanked 356 Times in 337 Posts iTrader Rating: (4/100% )	Attach the Negitive (-) to any metal bracket (like engine lifting hook) on the engine. Connect the Positive (+) to the bolt stud on the starter where the heavy battery cable is connected. Note, make sure that the positive (+) is not touching anything metal besides the stud sticking out of the starter...

11-29-2009, 10:06 AM	#3 (permalink)
ATSAaron ATS Racing Join Date: Sep 2005 Posts: 252 Thanks: 8 Thanked 14 Times in 13 Posts iTrader Rating: (5/100% )	Thanks. That is the correct answer. I have also used the two 10mm studs in the rear fuse box for charging, but not for jump starting. Aaron

01-17-2010, 01:30 AM	#4 (permalink)
Mr2civic817 Cage Fighter Join Date: Oct 2006 Location: Arlington Tx Posts: 189 Thanks: 11 Thanked 3 Times in 3 Posts iTrader Rating: (3/100% )	thanks alot guys, I needed this helpful tip