So the beams goes in this weekend - Page 2

WFX · 02-08-2007, 04:33 PM

Well I definately have that wire connected as well as it works when I was getting the engine codes from the ECU but it doesnt come on when I turn it to ignition!

mr220v · 02-08-2007, 04:48 PM

Quote:

Originally Posted by WFX

Well I definately have that wire connected as well as it works when I was getting the engine codes from the ECU but it doesnt come on when I turn it to ignition!

So you have pin 8 on the 22pin connector connected? If so, then that is my missing power supply wire.

Roman · 02-10-2007, 05:58 PM

Hey mr220v, one question, was your loom/ecu and auto or manual one?

mr220v · 02-12-2007, 09:20 AM

It is a manual loom. Cut of course.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

02-08-2007, 04:33 PM	#21 (permalink)
WFX Beams Owners Group Join Date: Jun 2006 Location: Perth, Western Australia Posts: 352 Thanks: 9 Thanked 13 Times in 10 Posts My Google Map iTrader Rating: (0/0% )	Well I definately have that wire connected as well as it works when I was getting the engine codes from the ECU but it doesnt come on when I turn it to ignition!

02-10-2007, 05:58 PM	#23 (permalink)
Roman Beams OCD Support Group Join Date: Feb 2006 Location: Auckland, NZ Posts: 946 Thanks: 23 Thanked 56 Times in 36 Posts My Google Map iTrader Rating: (2/100% )	Hey mr220v, one question, was your loom/ecu and auto or manual one?

02-12-2007, 09:20 AM	#24 (permalink)
mr220v Beams Owners Group Join Date: Mar 2006 Posts: 2,527 Thanks: 13 Thanked 176 Times in 147 Posts iTrader Rating: (11/100% )	It is a manual loom. Cut of course.