3SGE BEAMS - Red Top Wiring & Pinouts

WFX · 08-09-2009, 05:45 AM

Ok so I thought all this was in my last thread I made but I think its gotten lost down at the bottom somewhere so will start putting all I have up again in one single thread for you all.

I did spend many long hours working it all out but now it SHOULD be as simple as looking at coloured wires, looking at pins on plugs and connecting from there but if there is something that doesn't fit with what you have, then list it up here and I'm sure we can all work through it all.

My Information
My car was a 1993 Australian delivered Toyota Celica ST184 WRC.
My BEAMS Red Top Half Cut was from a 1998 Toyota Celica ST202.
IMPORTANT: Please bare this in mind while using my information

Here is the 1st lot of pinouts for connecting the Guage Cluster:

WFX · 08-09-2009, 06:24 AM

Ok hopefully this cheat guide will help some people out!

ST202 3SGE BEAMS
Light Grey Plug
Red/Black = Engine Warning Light On Dash
Yellow/Black = Oil Light On Dash
Yellow = Charge Warning Light On Dash
Brown = Earth
Red/Blue = 12 Volt To Alternator
Blue/Yellow = Water Temp
Grey = Tacho
Blue/Black = AirFlow Meter On ECU
Red/White = ?
Brown = Goes To Dark Grey Plug
Orange = ELS
White Plug
Orange = SPD (From SPD on ECU)
Purple = ?
Black/Yellow = STA (Start On ECU Where Wire Changes To Black)
Blue = Goes to Injector and Ignitor Wires On ECU
Blue = Goes No Where
Dark Grey Plug
Not Used

ST184 5SFE
White Plug
Black/White = No Where
Pink = Check Engine Light (Warning)
Yellow/Green = Water Temp
Black = Tacho
Yellow/Black = Oil Light
Dark Grey Plug
Brown = Earth
Black/Red = 12 Volt To Alternator
Yellow = Charge Warning Light
Dark Grey Plug On ECU
Blue/White = SPD (To SPD On ECU)
Orange = ELS

5SFE & BEAMS CONNECTIONS
List Of Connections You Need To Make
Speed Sensor
5SFE: Blue/White wire on ECU Dark Grey Plug
BEAMS: Orange Wire on White Plug
Check Engine Light
5SFE: Pink Wire on White Plug
BEAMS: Red/Black Wire on Light Grey Plug
Water Temp
5SFE: Yellow/Green Wire on White Plug
BEAMS: Blue/Yellow Wire on Light Grey Plug
Oil Light
5SFE: Yellow/Black Wire on White Plug
BEAMS: Yellow/Black Wire on Light Grey Plug
12 Volt To Alternator
5SFE: Black/Red Wire on Dark Grey Plug
BEAMS: Red/Blue Wire on Light Grey Plug
Speedo/ELS
5SFE: Orange Wire on ECU Dark Grey Plug
BEAMS: Orange Wire on Light Grey Plug

Now its been over 3 years since I wired this thing up so my current memory is a little sketchy but hopefuly that helps you. I never connected the A/C so if you want aircon you'll have to figure that out yourself I'm afraid.

Below I've also uploaded some PDF documents that I found helpful:
ST184 Wiring Diagrams
SXE10 Wiring Diagrams
ST202 AirCon Diagrams
ST215 Wiring Codes
ST215 Wiring Diagram
ST215 PinOut Guide

The ST215 PinOut Guide actually helped me the most. Some of the colours are not the same as the Red Top ECU but the pins and the function they control are pretty spot on! ENJOY!

pimmponk · 08-09-2009, 09:46 PM

thank u wayno!!!

puretone · 08-10-2009, 01:55 PM

PHOENIX: Sticky This!

puretone · 08-10-2009, 01:58 PM

Quote:

Originally Posted by pimmponk

thank u wayno!!!

Te ayuda esto con todo o necesitas saber mas?
Yo puse la caja de fusibles del ST184....no fue tan duro, solo q era cosa de aberiguar cual cable necesita q....y eso lo saque del harness del ST202 comparado con el del ST184...

puretone · 08-10-2009, 02:44 PM

pretty close to what I did I guess:

ST184 to ST202 BEAMS Dash
ST184 to ST202 BEAMS Dash
ST184 to ST202 BEAMS Dash

pimmponk · 08-10-2009, 04:37 PM

okk graxias puretone!!! disculpa las molestias al igual ke wayno! graxias por todo!
see ya!

PHOENIX · 08-19-2009, 03:43 AM

Info copied into the wiring diagram sticky at the top of the Beams section.

Thanks WFX!

08-09-2009, 05:45 AM	#1 (permalink)
WFX Beams Owners Group Join Date: Jun 2006 Location: Perth, Western Australia Posts: 352 Thanks: 9 Thanked 13 Times in 10 Posts My Google Map iTrader Rating: (0/0% )	3SGE BEAMS - Wiring & Pinouts Ok so I thought all this was in my last thread I made but I think its gotten lost down at the bottom somewhere so will start putting all I have up again in one single thread for you all. I did spend many long hours working it all out but now it SHOULD be as simple as looking at coloured wires, looking at pins on plugs and connecting from there but if there is something that doesn't fit with what you have, then list it up here and I'm sure we can all work through it all. My Information My car was a 1993 Australian delivered Toyota Celica ST184 WRC. My BEAMS Red Top Half Cut was from a 1998 Toyota Celica ST202. IMPORTANT: Please bare this in mind while using my information Here is the 1st lot of pinouts for connecting the Guage Cluster: Last edited by WFX; 08-10-2009 at 06:56 PM..

08-09-2009, 06:24 AM	#2 (permalink)
WFX Beams Owners Group Join Date: Jun 2006 Location: Perth, Western Australia Posts: 352 Thanks: 9 Thanked 13 Times in 10 Posts My Google Map iTrader Rating: (0/0% )	Ok hopefully this cheat guide will help some people out! ST202 3SGE BEAMS Light Grey Plug Red/Black = Engine Warning Light On Dash Yellow/Black = Oil Light On Dash Yellow = Charge Warning Light On Dash Brown = Earth Red/Blue = 12 Volt To Alternator Blue/Yellow = Water Temp Grey = Tacho Blue/Black = AirFlow Meter On ECU Red/White = ? Brown = Goes To Dark Grey Plug Orange = ELS White Plug Orange = SPD (From SPD on ECU) Purple = ? Black/Yellow = STA (Start On ECU Where Wire Changes To Black) Blue = Goes to Injector and Ignitor Wires On ECU Blue = Goes No Where Dark Grey Plug Not Used ST184 5SFE White Plug Black/White = No Where Pink = Check Engine Light (Warning) Yellow/Green = Water Temp Black = Tacho Yellow/Black = Oil Light Dark Grey Plug Brown = Earth Black/Red = 12 Volt To Alternator Yellow = Charge Warning Light Dark Grey Plug On ECU Blue/White = SPD (To SPD On ECU) Orange = ELS 5SFE & BEAMS CONNECTIONS List Of Connections You Need To Make Speed Sensor 5SFE: Blue/White wire on ECU Dark Grey Plug BEAMS: Orange Wire on White Plug Check Engine Light 5SFE: Pink Wire on White Plug BEAMS: Red/Black Wire on Light Grey Plug Water Temp 5SFE: Yellow/Green Wire on White Plug BEAMS: Blue/Yellow Wire on Light Grey Plug Oil Light 5SFE: Yellow/Black Wire on White Plug BEAMS: Yellow/Black Wire on Light Grey Plug 12 Volt To Alternator 5SFE: Black/Red Wire on Dark Grey Plug BEAMS: Red/Blue Wire on Light Grey Plug Speedo/ELS 5SFE: Orange Wire on ECU Dark Grey Plug BEAMS: Orange Wire on Light Grey Plug Now its been over 3 years since I wired this thing up so my current memory is a little sketchy but hopefuly that helps you. I never connected the A/C so if you want aircon you'll have to figure that out yourself I'm afraid. Below I've also uploaded some PDF documents that I found helpful: ST184 Wiring Diagrams SXE10 Wiring Diagrams ST202 AirCon Diagrams ST215 Wiring Codes ST215 Wiring Diagram ST215 PinOut Guide The ST215 PinOut Guide actually helped me the most. Some of the colours are not the same as the Red Top ECU but the pins and the function they control are pretty spot on! ENJOY! Last edited by WFX; 08-09-2009 at 09:28 PM..

08-19-2009, 03:43 AM	#8 (permalink)
PHOENIX Beams Owners Group Join Date: Mar 2005 Location: On Hiatus....... Posts: 9,266 Thanks: 92 Thanked 292 Times in 224 Posts Blog Entries: 1 My Google Map iTrader Rating: (49/100% )	Info copied into the wiring diagram sticky at the top of the Beams section. Thanks WFX! __________________ - Dave I'm moving so I need to downsize my collection/hoarding of MR2 Parts. Check out the for sale section to see what I have available!

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

LinkBacks (?) LinkBack to this Thread: http://www.mr2.com/forums/beams-owners-group/Toyota-MR2-44172-3sge-beams-red-top-wiring-pinouts.html
Posted By	For	Type	Date
Toyota Celica / Toyota Supra / Toyota MR-2 • ???????? ???? - ????????? ????	This thread	Refback	03-15-2010 07:10 AM

08-09-2009, 09:46 PM	#3 (permalink)
pimmponk Beams Owners Group Join Date: Feb 2009 Location: Chile Posts: 35 Thanks: 0 Thanked 0 Times in 0 Posts iTrader Rating: (0/0% )	thank u wayno!!!

08-10-2009, 01:55 PM	#4 (permalink)
puretone Beams Owners Group Join Date: Aug 2006 Location: Aruba, #1 BEAMS Engine on the Island Posts: 2,339 Thanks: 28 Thanked 57 Times in 56 Posts My Google Map iTrader Rating: (1/100% )	PHOENIX: Sticky This!

08-10-2009, 02:44 PM	#6 (permalink)
puretone Beams Owners Group Join Date: Aug 2006 Location: Aruba, #1 BEAMS Engine on the Island Posts: 2,339 Thanks: 28 Thanked 57 Times in 56 Posts My Google Map iTrader Rating: (1/100% )	pretty close to what I did I guess: ST184 to ST202 BEAMS Dash ST184 to ST202 BEAMS Dash ST184 to ST202 BEAMS Dash

08-10-2009, 04:37 PM	#7 (permalink)
pimmponk Beams Owners Group Join Date: Feb 2009 Location: Chile Posts: 35 Thanks: 0 Thanked 0 Times in 0 Posts iTrader Rating: (0/0% )	okk graxias puretone!!! disculpa las molestias al igual ke wayno! graxias por todo! see ya!