Help! front brake caliper reinstall problem
Posted 04-24-2009 at 04:17 AM by 420mr2
first post... I took off my calipers to get to my lower ball joints (they were acting up) everything went fine until i had to reinstall. First attempt I wasn't able to regain compression in the brakes (barely any, I would have to use my e brake if I wanted to drive anywhere) then I realized from my dad's advice that I didn't c clamp the piston all the way back in the caliper. Which I did the second time around, and gained full compression in my brakes after pumping them and adding new fluid, etc. I had perfect brakes for about a day and then lost compression again to the point where my car isn't driveable.
any ideas on what I did wrong?
any ideas on what I did wrong?
Total Comments 1
Comments
|
either you are not properly bleeding your brakes or soemthign is leakign and you are getting air in your brake lines
|
Posted 06-18-2009 at 04:45 PM by Red 2Deuce2
|
Recent Blog Entries by 420mr2
- How do I post? (07-17-2009)
- HELP!! mr2 not running :[ (06-15-2009)
- Help! front brake caliper reinstall problem (04-24-2009)
