2zz mr2 spyder swap mount question help please

where is the bridge mount located is it the pulley mount. im confused how many mount there are on the
2zz swap

some one posted this please read

-Engine mounts:
Gearbox Mount - 1ZZ
Intake Mount - 1ZZ
Manifold Mount - 1ZZ
Pulley Mount - 2ZZ

The 2zzge bridge mount needs to be drilled out to accept the bolt, it also needs to be slotted to the rear a little bit to make it line up correctly. You'll have to add some sort of spacing underneath to keep the pulley side of the engine from dropping too low. The right engine mount needs to be the 2zzge one or you can fab and mutilate the 1zzfe one to make it work. From what I've read, it's easiest to get the left mount in first, unbolt the right mount then bolt it to the bridge and then mess around with the right mount to get it to sit back in. You'll have to add spacers to the pulley mount because it's a little low. Drill out the hole so it'll accept the 17mm bolt and slot it a little so that the engine sits forward instead of crooked. Put 10mm spacers on the left tranny mount and the engine will sit perfectly in the car.


SO IS THE BRIDGE MOUNT THE PULLEY MOUNT THANKS