I am trying to purchase the correct ball joints for my 1991 MKII Non-Turbo. Perfect Cicle and MOOG parts ordered at two different auot parts stores do not fit in the spindle hub (see attached photo). The base is too large leaving the bolt tabs about .25" away from seating properly in the hub. This has to be a common problem as the parts I ordered looked like they had been returned from another frustrated owner/mechanic. Can anyone tell me if this is a common problem?

Ken92677

where is the bridge mount located is it the pulley mount. im confused how many mount there are on the
2zz swap

some one posted this please read

-Engine mounts:
Gearbox Mount - 1ZZ
Intake Mount - 1ZZ
Manifold Mount - 1ZZ
Pulley Mount - 2ZZ

The 2zzge bridge mount needs to be drilled out to accept the bolt, it also needs to be slotted to the rear a little bit to make it line up correctly. You'll have to add some sort...

johnathan

some one told me the tps wires should be cut and reversed is this true is that whaT they mean by swap. and does the fuel rail from the 1zz go on the 2zz . and where is the bridge mount located is it the pulley mount. im confused how many mount there are on the
2zz swap

johnathan

some one told me the tps wires should be cut and reversed is this true is that whaT they mean by swap. and does the fuel rail from the 1zz go on the 2zz thanks

johnathan

Can anyone tell me what a reasonable price for a used 85 MR2 engine would be? i guess its got some water in it and needs some work, i dont know what they usually run for!

Scooterpie