Anyone doing swaps in / or near Pittsburgh??

swartzzz · 07-22-2007, 03:01 PM

Any shops around the northeast doing swaps on N/A Mr2's??? I am contemplating one...

Greg

Hot_Karl · 08-23-2007, 12:23 PM

you could check out PITTspeed.com and ask there if anyone will do it.
I know burnyD got his done by FirstTry > First Try Engineering

billyboy · 09-14-2007, 08:58 PM

I'm right in the middle of a 20V swap in south central PA. In fact, I'm hoping tomorrow is the big day that the motor goes in, but I bought a full gasket set from Hanover Toyota that needs to be put in, plus new clutch and so on and so on... I'm also close to the owner of twosrus.com, he's done at least one swap that I know of with a 2ZZ in a MKIII.

Bill

07-22-2007, 03:01 PM	#1 (permalink)
swartzzz No Skills Join Date: Jul 2007 Posts: 15 Thanks: 0 Thanked 0 Times in 0 Posts iTrader Rating: (0/0% )	Anyone doing swaps in / or near Pittsburgh?? Any shops around the northeast doing swaps on N/A Mr2's??? I am contemplating one... Greg

09-14-2007, 08:58 PM	#3 (permalink)
billyboy Old guy Join Date: Jul 2007 Location: York, PA Posts: 15 Thanks: 0 Thanked 1 Time in 1 Post iTrader Rating: (0/0% )	20V swap in York, PA I'm right in the middle of a 20V swap in south central PA. In fact, I'm hoping tomorrow is the big day that the motor goes in, but I bought a full gasket set from Hanover Toyota that needs to be put in, plus new clutch and so on and so on... I'm also close to the owner of twosrus.com, he's done at least one swap that I know of with a 2ZZ in a MKIII. Bill

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

LinkBacks (?) LinkBack to this Thread: http://www.mr2.com/forums/engine-swaps/Toyota-MR2-19259-anyone-doing-swaps-near-pittsburgh.html
Posted By	For	Type	Date
Toyota MR2 Message Board	This thread	Refback	09-14-2007 10:09 PM

08-23-2007, 12:23 PM	#2 (permalink)
Hot_Karl I'm Hot Join Date: Nov 2006 Location: Pittsburgh Posts: 27 Thanks: 0 Thanked 1 Time in 1 Post iTrader Rating: (0/0% )	you could check out PITTspeed.com and ask there if anyone will do it. I know burnyD got his done by FirstTry > First Try Engineering