parts

[mysc12]

hay i was wonder can u still get oil pan bolts need like 20 of them and the fip sealant? and does trd header take a diff gasket than the oem cast manifold

1988 mr2 4agze

[te51levin]

There are nineteen bolts, part number 90119-06206; two studs, part number 90116-06022; two nuts, part number 90080-17210. The nuts are sold in bags of ten, so if you order two, you will be charged for and receive ten. Black FIPG (black stuff is for engines, red for transmissions) is 00295-00103.

The TRD header can use the same gasket as the stock exhaust manifold. The part number is 17173-16011 for that unit.

[mysc12]

hay thanks man im glad there some one out there to help all of the toyota guys out
so as far as the fip sealant stuff for the oil pan all the car it list for are 1990 and newer this shouldn't matter right on what one i order right.
and as far as the nuts for the studs it only charging far 0ne or two no 12 will this change after i order?
And can i have it shipped to my local toyota dealer? so i dont have to pay shipping cost cuz for 19 small bolts its 8 bucks for shipping
thanks again

[te51levin]

You're ordering everything by part number, so if the website lists different choices after you put that part number in, it makes no difference which one you choose. They are all the same - the website does that with any part that is used on more than one car.

Hardware is sold individually. After you add the parts to your shopping cart, you should see the quantity (Qty) for each part listed right down the center of the page. This is where you set the quantity that you want to buy of each part. Do this before you check out.

Each Toyota dealer works in competition with each other, not in partnership, and your local dealership would not think it was very cute if you walked in to their place to pick up parts that you purchased from someone else. So either we need to send them directly to you (which will probably cost less in real life so you'd get a little back), or you can select the "local pickup" option on shipping, and then come pick your order up at our place. Weren't you planning on bringing your header by anyway so I could build the b-pipe for it?

[mysc12]

ya i did need to get up there for sure u just needed the header right
all try to figure all the parts i need and just make one order

i was checking around for a post for a fuel line i need didnt find anything so please tell me u can still get it ......the one from the tank to the filter well i think it goes to the tank its the inlet line

[te51levin]

Originally Posted by mysc12

ya i did need to get up there for sure u just needed the header right

Yup, all I need is the header.

Originally Posted by mysc12

i was checking around for a post for a fuel line i need didnt find anything so please tell me u can still get it ......the one from the tank to the filter well i think it goes to the tank its the inlet line

The rubber fuel line from the hard line on the pump bracket to the bottom (inlet) of the fuel filter is 90923-01327, and it is actually still available.