FS Mark1 Parts-- Big and small-- Part2

mr2tim · 09-14-2009, 09:15 PM

Check this weird list of panels and parts. I sawed up my parts car which was stored without rust and have some interesting INTERIOR panels that I've never seen for sale before here.

I have priced this list out yet but I have pictures of anything here if you want to check it out.

Happy Motoring Ya'll

mr2tim

Added 9-09-----------------------------------------------------------------
************************************************** ****
Replacement Rocker panels, both sides
Sunroof frame (perfect no rust)
Replacement floor pans:
a. drs seat floor and forward floor under the pedals
b. pass “ floor and “ “ under the glove box
c. front trunk floor
d. rear trunk floor
Replacement drivers seat floor reinforcement beam w OEM seat receiving nuts for the seat
“ pass seat floor reinforcement beam “ " “
nuts for the seat
Rear valance-under the rear bumper with air breather holes
Rear panel- holds license plate and trunk latch
Complete battery holder bracket (most of it)
Left and right manual doors, glass
Door hinges (separate)
Seat Belt receiver, black w elect pigtail, drivers side
Exterior gas fuel door
Fuel Inj ballast 85-86
Radiator lower support 85-86 only (vertical)
Air filter 87-89 (in the trunk)
Shelby 14” rims (trimmed in your color)
Pass seat, blue fabric, 87-89 series (new?)
Pass door, manual, 85-86 panel type, black, real pretty
Drs “ , “ , recoverable “
Rt front axle assembly
a. lower arm
b. caliper
c. bearing carrier assembly
d. strut
Left front axle assembly
e. lower arm
f. caliper
g. bearing carrier assembly
h. strut

Electrical harness for chassis (include engine room fuse box)
Electrical engine harness for N/A engine
Fuse box (drivers foot area)
Complete steering column, ignition, blue wheel & lower U-joint
Dashboard reinforcement bar
Dashboard electrical harness (includes A/C hook-ups)
Automatic AT CV (half-shaft) Drs side only
Rt Rear axle assembly
a. Caliper
b. Forward Strut Bar
c. Lower control arm
d. Brake rotor

Left Rear axle assembly
e. Caliper
f. Bearing Carrier (N/A)
g. Forward Strut Bar
h. Toe-in adjuster
i. Lower control arm
j. Brake rotor
Chasis mounting bracket-rear L&R 85-86 (these differ from 87-89)
Chasis “ “ - rear L&R 87-89 (these differ from 85-86)
Chasis “ “ -front left and right (for frt strut bar)
Gas Fill piping-to tank w cap from fuel door
Rack and Pinion steering assembly
Rear Trunk Lockset (85-86 only-short depth type)
Temp Sensors-Engine and Radiator
Emer Brake Lever Assembly, w cable, switch- 85-86 (left side of console))
Engine cover Latch Trim/Garnish (2 types-behind drs seat)
Strut swivel top-front-4 bolt
Fuse Box-engine room (has harness)
Dash speakers
Fuel door & trunk opening levers assembly (cables available)\
Upper rad straps -85-86 only (small curved ones)
Water filler inlet w cap
Fuel injectors 4 ea for 4a series engines
Turn signal stalk w 4 way flasher
Ignition w key –column available
Universal joint for steering column base
Gasoline overflow consolidator (bolts to firewall/engine compartment)
Fuel gauge
Water temp gauge
Alternator gauge
Brake footpedal assembly for automatic cars
Junction Box #3
Ac clutch stator (new)
Calipers (all)
Fuse box (interior w harness)
A/C fuse box (pass kick area)
Defroster diverter

If you don’t see what you want write me, lots of stuff wasn’t inventoried and small parts are available to Club Members Only !

stu4u3 · 09-16-2009, 05:10 PM

Hi again Tim. Do you have the rubber caps that go over the top of the strut housings (front and back)?

mr2tim · 09-19-2009, 04:20 PM

Hiya Stuee..

I have 2 rubber caps and will trade for your first born male child?

Quote:

Originally Posted by stu4u3

Hi again Tim. Do you have the rubber caps that go over the top of the strut housings (front and back)?

stu4u3 · 09-19-2009, 09:04 PM

Quote:

Originally Posted by mr2tim

Hiya Stuee..

I have 2 rubber caps and will trade for your first born male child?

LOL. Well, that might be difficult since I'm "fixed" and we only have a daughter.

How much man? Later.

moy407 · 09-19-2009, 11:19 PM

do you have the trim panel, the square bezel around the a/c switch and stereo unit.

contro · 09-27-2009, 03:56 AM

Fuel door
j. Brake rotor
Exterior gas fuel door

I am intrested in these pm sent

flybikes1593 · 10-01-2009, 11:00 AM

how much for hinges?
i need a pair for the drivers side that aren't sloppy and are in good shape

jsnod25 · 10-01-2009, 12:43 PM

i need a dash board... the whole thing.... got one? preferably black, but i can paint it if you dont have one. also if you have interior door panels for manual windows in black, that would be cool, and i need a black center console... oh and headlight eyelids x 2, black if possible, if not ill paint.

09-14-2009, 09:15 PM	#1 (permalink)
mr2tim SUPERcharZed ToyZ RacZer Join Date: Mar 2008 Location: South Florida Posts: 1,789 Thanks: 8 Thanked 118 Times in 111 Posts My Google Map iTrader Rating: (6/100% )	FS Mark1 Parts-- Big and small-- Part2 Check this weird list of panels and parts. I sawed up my parts car which was stored without rust and have some interesting INTERIOR panels that I've never seen for sale before here. I have priced this list out yet but I have pictures of anything here if you want to check it out. Happy Motoring Ya'll mr2tim Added 9-09----------------------------------------------------------------- ************************************************ ** Replacement Rocker panels, both sides Sunroof frame (perfect no rust) Replacement floor pans: a. drs seat floor and forward floor under the pedals b. pass “ floor and “ “ under the glove box c. front trunk floor d. rear trunk floor Replacement drivers seat floor reinforcement beam w OEM seat receiving nuts for the seat “ pass seat floor reinforcement beam “ " “ nuts for the seat Rear valance-under the rear bumper with air breather holes Rear panel- holds license plate and trunk latch Complete battery holder bracket (most of it) Left and right manual doors, glass Door hinges (separate) Seat Belt receiver, black w elect pigtail, drivers side Exterior gas fuel door Fuel Inj ballast 85-86 Radiator lower support 85-86 only (vertical) Air filter 87-89 (in the trunk) Shelby 14” rims (trimmed in your color) Pass seat, blue fabric, 87-89 series (new?) Pass door, manual, 85-86 panel type, black, real pretty Drs “ , “ , recoverable “ Rt front axle assembly a. lower arm b. caliper c. bearing carrier assembly d. strut Left front axle assembly e. lower arm f. caliper g. bearing carrier assembly h. strut Electrical harness for chassis (include engine room fuse box) Electrical engine harness for N/A engine Fuse box (drivers foot area) Complete steering column, ignition, blue wheel & lower U-joint Dashboard reinforcement bar Dashboard electrical harness (includes A/C hook-ups) Automatic AT CV (half-shaft) Drs side only Rt Rear axle assembly a. Caliper b. Forward Strut Bar c. Lower control arm d. Brake rotor Left Rear axle assembly e. Caliper f. Bearing Carrier (N/A) g. Forward Strut Bar h. Toe-in adjuster i. Lower control arm j. Brake rotor Chasis mounting bracket-rear L&R 85-86 (these differ from 87-89) Chasis “ “ - rear L&R 87-89 (these differ from 85-86) Chasis “ “ -front left and right (for frt strut bar) Gas Fill piping-to tank w cap from fuel door Rack and Pinion steering assembly Rear Trunk Lockset (85-86 only-short depth type) Temp Sensors-Engine and Radiator Emer Brake Lever Assembly, w cable, switch- 85-86 (left side of console)) Engine cover Latch Trim/Garnish (2 types-behind drs seat) Strut swivel top-front-4 bolt Fuse Box-engine room (has harness) Dash speakers Fuel door & trunk opening levers assembly (cables available)\ Upper rad straps -85-86 only (small curved ones) Water filler inlet w cap Fuel injectors 4 ea for 4a series engines Turn signal stalk w 4 way flasher Ignition w key –column available Universal joint for steering column base Gasoline overflow consolidator (bolts to firewall/engine compartment) Fuel gauge Water temp gauge Alternator gauge Brake footpedal assembly for automatic cars Junction Box #3 Ac clutch stator (new) Calipers (all) Fuse box (interior w harness) A/C fuse box (pass kick area) Defroster diverter If you don’t see what you want write me, lots of stuff wasn’t inventoried and small parts are available to Club Members Only !

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

09-16-2009, 05:10 PM	#2 (permalink)
stu4u3 Fixing up a 1989 MR2 MK1 Join Date: Mar 2009 Location: Dallas/Fort Worth Posts: 351 Thanks: 14 Thanked 6 Times in 6 Posts iTrader Rating: (1/100% )	Hi again Tim. Do you have the rubber caps that go over the top of the strut housings (front and back)?

09-19-2009, 11:19 PM	#5 (permalink)
moy407 No Skills Join Date: Sep 2009 Location: Orlando, FL Posts: 3 Thanks: 1 Thanked 0 Times in 0 Posts iTrader Rating: (0/0% )	do you have the trim panel, the square bezel around the a/c switch and stereo unit.

09-27-2009, 03:56 AM	#6 (permalink)
contro No Skills Join Date: Sep 2009 Location: Northern NJ Posts: 3 Thanks: 0 Thanked 0 Times in 0 Posts iTrader Rating: (0/0% )	Fuel door j. Brake rotor Exterior gas fuel door I am intrested in these pm sent

10-01-2009, 11:00 AM	#7 (permalink)
flybikes1593 Cage Fighter Join Date: Jun 2009 Location: Neenah Posts: 126 Thanks: 0 Thanked 3 Times in 3 Posts iTrader Rating: (0/0% )	how much for hinges? i need a pair for the drivers side that aren't sloppy and are in good shape

10-01-2009, 12:43 PM	#8 (permalink)
jsnod25 How did this get changed? Join Date: Sep 2009 Location: Va beach, va Posts: 133 Thanks: 6 Thanked 0 Times in 0 Posts iTrader Rating: (0/0% )	i need a dash board... the whole thing.... got one? preferably black, but i can paint it if you dont have one. also if you have interior door panels for manual windows in black, that would be cool, and i need a black center console... oh and headlight eyelids x 2, black if possible, if not ill paint.