Cup holder

[scottohno]

thanks for the thanks. its my first one!

[YellowJacket]

Originally Posted by surfer8

I think a spacer made of fuel line is a great idea. If my interior was that nice I would be nervous about a single set of screws (even though the floor ridge and pipe insulation would give some additional support).

the rattle happens cause the cupholder is (was) bouncing. Now that it has some foam between the floor hump and the cupholder the rattle is gone. If the bracket simply lowered the entire cupholder off the seat about 1/3 inch so it was resting there it would also alleviate the problem. The up bounce is also a concern as mentioned, so it would be best to have it more secure to the seat with some of the front screws and some spacer solution, I agree.

The comment above about mounting it to the hump on the floor instead of the seat is a definite possibility. No comment is an offensive comment here... all comments welcome as its all in fun!

Scott- my floormats are jkoller's repro and I ordered them from twosrus, yes. The seats/door cards/sunvisors were recovered by a previous owner back in 1999 at a place in Memphis...
I posted a show-off thread The Yellow Jacket if you want to see more of the car.

Here is the receipt for the interior work.