About to yank my 4age

deuces · 07-09-2006, 05:12 AM

The rings are bad so im gonna yank the engine and rebuild it. If anyone is intersested Ill give updates on how its goin. Any known problems to look out for would be great.

MosquitoXR13 · 07-09-2006, 12:17 PM

Go for it!! I plan to buy a broken 4AGZE and rebuild that to replace my tired, 187,XXX mile 4AGE. Good luck and give up dates!!!!

SilverMR2 · 07-09-2006, 10:17 PM

If its smoking plan to put a set of pistons in it. If yousearch for an earlier thread of mine you'll see why. about halfway down is the pic http://www.mr2board.com/forums/gener...need-help.html

deuces · 07-10-2006, 12:51 AM

Is there a good rebuilder or machine shop in Phoenix? How bout a line on a good rebuild kit? Phone # or website

SilverMR2 · 07-11-2006, 06:24 PM

The kit i bought when i did mine had top pro pistons and bearings and a felpro gasket kit it was 400 bucks. stuff looked ok not the best but not the worst i have seen

07-09-2006, 05:12 AM	#1 (permalink)
deuces I see u in my rearview Join Date: Jul 2006 Posts: 16 Thanks: 0 Thanked 0 Times in 0 Posts iTrader Rating: (0/0% )	About to yank my 4age The rings are bad so im gonna yank the engine and rebuild it. If anyone is intersested Ill give updates on how its goin. Any known problems to look out for would be great.

07-10-2006, 12:51 AM	#4 (permalink)
deuces I see u in my rearview Join Date: Jul 2006 Posts: 16 Thanks: 0 Thanked 0 Times in 0 Posts iTrader Rating: (0/0% )	AZ engine rebuilder? Is there a good rebuilder or machine shop in Phoenix? How bout a line on a good rebuild kit? Phone # or website

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

07-09-2006, 12:17 PM	#2 (permalink)
MosquitoXR13 AW11 Noobie Join Date: Jun 2006 Location: Rochester, NY Posts: 158 Thanks: 2 Thanked 0 Times in 0 Posts iTrader Rating: (0/0% )	Go for it!! I plan to buy a broken 4AGZE and rebuild that to replace my tired, 187,XXX mile 4AGE. Good luck and give up dates!!!!

07-09-2006, 10:17 PM	#3 (permalink)
SilverMR2 Cage Fighter Join Date: Apr 2006 Location: Orlando, Fl Posts: 137 Thanks: 0 Thanked 0 Times in 0 Posts iTrader Rating: (0/0% )	If its smoking plan to put a set of pistons in it. If yousearch for an earlier thread of mine you'll see why. about halfway down is the pic http://www.mr2board.com/forums/gener...need-help.html

07-11-2006, 06:24 PM	#5 (permalink)
SilverMR2 Cage Fighter Join Date: Apr 2006 Location: Orlando, Fl Posts: 137 Thanks: 0 Thanked 0 Times in 0 Posts iTrader Rating: (0/0% )	The kit i bought when i did mine had top pro pistons and bearings and a felpro gasket kit it was 400 bucks. stuff looked ok not the best but not the worst i have seen