PN:engine

[blakecj7]

Engine:
oil filter - 90915-YZZF2
n/a fuel filter - 23300-19175
n/a timing belt - 13568-19145
n/a timing belt idler pulley - 13505-16021
n/a water pump - 16100-19115
n/a distributor cap - 19101-16220 (88-89)
n/a distributor cap - 19101-16080 ( 85-87)
n/a distributor rotor - 19102-73180
n/a spark plug wires - 90919-21350 (85-87)
valve cover gaskets
11213-16010 - Left and Right (you need 2)
11214-16020 - Center
n/a full engine gasket kit - 04111-16076
s/c Full engine gasket set - 04111-16113
s/c Crank Pulley key - 95161-10519
s/c Headbolt - 90910-02121/90910-02120 (there are long and short ones, I dont know which part # is for which)
s/c Headbolt washer - 90201-10344
s/c Injector seal (bottom insulator, not the o-ring) - 23291-41010
s/c pistons & rings
pistons std:13101-16100-01 4AGZE, AW11 STD MARK1
13101-16100-02 4AGZE, AW11 STD MARK1
13101-16100-03 4AGZE, AW11 STD MARK1
piston oversize:13103-16100 4AGZE, AW11 O/S .50mm
rings oversize:13013-16090 4AGZE, AW11 O/S .50mm
s/c dipstick - 15301-16030
front engine mount bolt (long) - 90105-12095
front engine mount nut - 90179-12025
s/c rear engine mount - 12371-16070
n/a afm - 22250-16020 (85-86)
n/a afm - 22250-16040 (87-89)
s/c afm - 22250-16090
n/a throttle cable - 78180-17030
s/c throttle cable w/o cruise - 78180-17110
s/c throttle cable w/cruise - 78180-17120
oil pane drain plug - 90341-12012
oil cooler valve -- 15131-38030
seal for oil cooler valve -- 96711-24013
spring for oil cooler valve -- 15132-21010
oil cooler -block O ring -- 96732-31060
oil cooler halves o Ring -- 90029-20013
oil cooler plate Washer -- 90201-19272
oil cooler return crush washers (on pan) -- 90430-14235
valve cover washer seals -- 90210-06013
upper timing cover gasket -- 11319-16011
middle timing cover gasket -- 11329-16010
water seal (Drivers side of head) -- 11182-16020
water seal (outlet of pump) -- 16341-16020
intake to TVIS gasket -- 17171-16012
TVIS to Head gask. -- 17177-16012
cold start inj. gask -- 23293-42010
EGR inlet gask -- 25628-16010
throttle body gasket -- 22271-16020
injector grommets -- 90480-13005
inj. insulators -- 23291-41010
inj. O rings -- 90301-07001
head gasket -- 11115-16070
oil pump assembly -- 15100-19036
oil pump strainer/pickup -- 15104-15090
oil pump gasket -- 15134-20010
oil cap gasket -- 11383-16010
water pump O ring's' -- 96761-24035 90430-37140
fuel rail and oil return crush washers
Fuel rail -- 90430-08005
90430-12005
Toyota Grey bond sealant -- 00295-00103

[2restomod]

Thanks. The number I have for standard gze (SC) piston rings is 13011-16090. Also, I just ordered main bearings for the crank (don't see those listed) and that number is 11701-16010-03 for the #3 standard bearings. I assume the 1's would end in "-01" and the two's "-02", etc?