Supercharged help please!!

mr2drummer · 11-26-2008, 12:46 AM

I have a 88 superchared with a HKS pulley, and everything else all stock. A couple of months ago I noticed when I drive on the highway for 10 minutes or so that my exhuast manifold will start to glow red. I have taken the cat and muffler out of the system and even the flex pipe section and it still does it, checked cam timing, ignition timing, fuel pressure, and everything else there is to check. The car still runs like it always has, it runs perfect just the exhaust glows, Has anyone else with a SC noticed this after driving for a while? Maybe its normal? On mine you cant see it through the heat shield, but if you look underneath it between the heat shields it glows cherry red.
Thanks for any advice...

SW21T · 11-26-2008, 12:57 AM

well i have the mkII so im not 100% sure but i just saw a vid on this and its just the exhaust nutting is wrong with ur car pipping can be thin that it glows cuz its too hot for it thats my guess from what i saw

Papo J · 11-26-2008, 09:10 AM

Not enough timing will cause that, what is the timing set at now?

Jackstand Queen · 11-26-2008, 12:08 PM

I don't think its normal for the headers to be cherry, or even orange hot. I had that condition on my SC14 charged motor when it was running like butt. I got it running good now, and they don't glow in the dark. I would suspect the condition has something to do with the fuel air ratio your engine is utilizing.

mr2drummer · 11-26-2008, 06:56 PM

I have my timing set a 10 deg. I think, its whatever it said on the engine cover and the book. its set to stock.
Thanks

Papo J · 11-27-2008, 05:49 PM

You're not using an MSD box are you? Make sure you have it set at 10* before top dead center not just 10*, not saying that you did it wrong but plenty of people here have before.

curvesrgood · 11-30-2008, 01:23 PM

Mine only glows after a good, hard drive and then if I bring her right in to park in the shed out back... this goes for both my N/A and S/C cars. Otherwise they don't glow.

ToyotaTechGeek · 11-30-2008, 09:02 PM

how do your plugs look? which plugs are you running?

mr2tim · 11-30-2008, 09:47 PM

Been drivin' mine for 19 years and never noticed but now I'm gonna look.

I am curious, since your running that HKS pulley if your looking at the left notch then it's correct. Looking in the filler cap for the cam indentation confirms this.

When I first bought my car in '89 I heard tell of SCCA racers that ran headers in competition and if they didn't "wrap" the headers, fires were widespread.

An interesting note: when I was crusin' the Internet for a S/C distributor in foreign yards afew months back there were a whole lot of Mark1's that had "fire damages" that melted the distributor I needed?

My 4a-gze parts engine out back was a "fire" engine too.

11-26-2008, 12:46 AM	#1 (permalink)
mr2drummer No Skills Join Date: Nov 2008 Posts: 2 Thanks: 0 Thanked 0 Times in 0 Posts iTrader Rating: (0/0% )	Supercharged help please!! I have a 88 superchared with a HKS pulley, and everything else all stock. A couple of months ago I noticed when I drive on the highway for 10 minutes or so that my exhuast manifold will start to glow red. I have taken the cat and muffler out of the system and even the flex pipe section and it still does it, checked cam timing, ignition timing, fuel pressure, and everything else there is to check. The car still runs like it always has, it runs perfect just the exhaust glows, Has anyone else with a SC noticed this after driving for a while? Maybe its normal? On mine you cant see it through the heat shield, but if you look underneath it between the heat shields it glows cherry red. Thanks for any advice...

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

11-26-2008, 12:57 AM	#2 (permalink)
SW21T 400HP 3rd gen?? Join Date: Nov 2008 Location: Washington St Posts: 1,853 Thanks: 143 Thanked 32 Times in 30 Posts iTrader Rating: (18/100% )	well i have the mkII so im not 100% sure but i just saw a vid on this and its just the exhaust nutting is wrong with ur car pipping can be thin that it glows cuz its too hot for it thats my guess from what i saw

11-26-2008, 09:10 AM	#3 (permalink)
Papo J 6SPD GTE Join Date: Sep 2006 Posts: 588 Thanks: 2 Thanked 50 Times in 49 Posts iTrader Rating: (0/0% )	Not enough timing will cause that, what is the timing set at now?

11-26-2008, 12:08 PM	#4 (permalink)
Jackstand Queen Cage Fighter Join Date: May 2008 Posts: 840 Thanks: 75 Thanked 64 Times in 60 Posts iTrader Rating: (1/100% )	I don't think its normal for the headers to be cherry, or even orange hot. I had that condition on my SC14 charged motor when it was running like butt. I got it running good now, and they don't glow in the dark. I would suspect the condition has something to do with the fuel air ratio your engine is utilizing.

11-26-2008, 06:56 PM	#5 (permalink)
mr2drummer No Skills Join Date: Nov 2008 Posts: 2 Thanks: 0 Thanked 0 Times in 0 Posts iTrader Rating: (0/0% )	I have my timing set a 10 deg. I think, its whatever it said on the engine cover and the book. its set to stock. Thanks

11-27-2008, 05:49 PM	#6 (permalink)
Papo J 6SPD GTE Join Date: Sep 2006 Posts: 588 Thanks: 2 Thanked 50 Times in 49 Posts iTrader Rating: (0/0% )	You're not using an MSD box are you? Make sure you have it set at 10* before top dead center not just 10*, not saying that you did it wrong but plenty of people here have before.

11-30-2008, 01:23 PM	#7 (permalink)
curvesrgood three mk1's Join Date: Feb 2006 Location: NC Posts: 499 Thanks: 8 Thanked 33 Times in 28 Posts iTrader Rating: (1/100% )	Mine only glows after a good, hard drive and then if I bring her right in to park in the shed out back... this goes for both my N/A and S/C cars. Otherwise they don't glow.

11-30-2008, 09:02 PM	#8 (permalink)
ToyotaTechGeek resident GEEK! Join Date: Mar 2005 Location: ...boosting mid-corner Posts: 995 Thanks: 14 Thanked 31 Times in 31 Posts My Google Map iTrader Rating: (2/100% )	how do your plugs look? which plugs are you running?

11-30-2008, 09:47 PM	#9 (permalink)
mr2tim SUPERcharZed ToyZ RacZer Join Date: Mar 2008 Location: South Florida Posts: 1,789 Thanks: 8 Thanked 118 Times in 111 Posts My Google Map iTrader Rating: (6/100% )	Been drivin' mine for 19 years and never noticed but now I'm gonna look. I am curious, since your running that HKS pulley if your looking at the left notch then it's correct. Looking in the filler cap for the cam indentation confirms this. When I first bought my car in '89 I heard tell of SCCA racers that ran headers in competition and if they didn't "wrap" the headers, fires were widespread. An interesting note: when I was crusin' the Internet for a S/C distributor in foreign yards afew months back there were a whole lot of Mark1's that had "fire damages" that melted the distributor I needed? My 4a-gze parts engine out back was a "fire" engine too.