wheel offset??

MRtuned · 08-18-2007, 10:29 PM

whats the recommended wheel offset for 8" wide wheels on an sw20?

RePete · 08-18-2007, 11:20 PM

Front: +35 to +38ish
Rear: +25 to +38ish

MRtuned · 08-19-2007, 01:19 PM

if I got wheels with a 46mm offset that were 8" wide, would they rub? if so how bad. could I run them safely? thanks!

oh btw what is the stock hub bore on an MR2? thanks!

RePete · 08-19-2007, 03:47 PM

You need either 10mm spacers to run them safely or a new plan.

Standard MKII wheel bore size is 60.1mm.

MRtuned · 08-19-2007, 09:30 PM

aww that sucks. they seemed like nice wheels too. enkei, 16x8, etc... well I'll just try and get some integrals then. thanks!

08-18-2007, 10:29 PM	#1 (permalink)
MRtuned n/a auto to gen III Join Date: Jul 2007 Location: Mankato, Minnesota Posts: 653 Thanks: 26 Thanked 21 Times in 8 Posts My Google Map iTrader Rating: (1/100% )	wheel offset?? whats the recommended wheel offset for 8" wide wheels on an sw20?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

LinkBacks (?) LinkBack to this Thread: http://www.mr2.com/forums/mk2-braking-suspension-wheels/Toyota-MR2-20164-wheel-offset.html
Posted By	For	Type	Date
Toyota MR2 Message Board	This thread	Refback	08-19-2007 12:23 AM

08-18-2007, 11:20 PM	#2 (permalink)
RePete No Frills Join Date: Feb 2005 Location: Western Canada Posts: 3,896 Thanks: 0 Thanked 254 Times in 244 Posts Blog Entries: 4 iTrader Rating: (3/100% )	Front: +35 to +38ish Rear: +25 to +38ish

08-19-2007, 01:19 PM	#3 (permalink)
MRtuned n/a auto to gen III Join Date: Jul 2007 Location: Mankato, Minnesota Posts: 653 Thanks: 26 Thanked 21 Times in 8 Posts My Google Map iTrader Rating: (1/100% )	if I got wheels with a 46mm offset that were 8" wide, would they rub? if so how bad. could I run them safely? thanks! oh btw what is the stock hub bore on an MR2? thanks!

08-19-2007, 03:47 PM	#4 (permalink)
RePete No Frills Join Date: Feb 2005 Location: Western Canada Posts: 3,896 Thanks: 0 Thanked 254 Times in 244 Posts Blog Entries: 4 iTrader Rating: (3/100% )	You need either 10mm spacers to run them safely or a new plan. Standard MKII wheel bore size is 60.1mm.

08-19-2007, 09:30 PM	#5 (permalink)
MRtuned n/a auto to gen III Join Date: Jul 2007 Location: Mankato, Minnesota Posts: 653 Thanks: 26 Thanked 21 Times in 8 Posts My Google Map iTrader Rating: (1/100% )	aww that sucks. they seemed like nice wheels too. enkei, 16x8, etc... well I'll just try and get some integrals then. thanks!