October 2008 MR2 Showcase - Page 2

kevinioflosangeles · 10-18-2008, 01:19 PM

I see that the engine lid latch has been sacrificed. Was a hole needed in the wall between engine bay and trunk?

kevinioflosangeles · 10-18-2008, 07:32 PM

the trunk need to be altered?

Stados · 10-18-2008, 09:55 PM

No firewall cut. Only removing the lach from the engine bay and Engine Lid. Intake is too big on Beams

kevinioflosangeles · 10-18-2008, 10:53 PM

OK, this is the direction I'm going when I get down to it!

10-18-2008, 07:32 PM	#22 (permalink)
kevinioflosangeles No Skills Join Date: Oct 2008 Posts: 11 Thanks: 0 Thanked 0 Times in 0 Posts iTrader Rating: (0/0% )	Did the wall between the engine bay and the trunk need to be altered?

10-18-2008, 10:53 PM	#24 (permalink)
kevinioflosangeles No Skills Join Date: Oct 2008 Posts: 11 Thanks: 0 Thanked 0 Times in 0 Posts iTrader Rating: (0/0% )	Boogie! OK, this is the direction I'm going when I get down to it!

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

10-18-2008, 01:19 PM	#21 (permalink)
kevinioflosangeles No Skills Join Date: Oct 2008 Posts: 11 Thanks: 0 Thanked 0 Times in 0 Posts iTrader Rating: (0/0% )	I see that the engine lid latch has been sacrificed. Was a hole needed in the wall between engine bay and trunk?

10-18-2008, 09:55 PM	#23 (permalink)
Stados Beams Owners Group Join Date: Jun 2008 Posts: 35 Thanks: 1 Thanked 2 Times in 2 Posts iTrader Rating: (0/0% )	No firewall cut. Only removing the lach from the engine bay and Engine Lid. Intake is too big on Beams