1zz & 2zz Stainless steel flanges, plus turbo manifold starter bits

[Brad Bedell]

I'm cleaning out the garage: I have the following flanges left over and I won't be producing any more of these, get them while they last. Feel free to make me a reasonable offer, if I'm out of line on current market value. All are 304 stainless unless otherwise noted:

four 3/8" thick 1zz flanges they are 304 stainless. Holes are 1.5" ID. $60.00 each

one 1/2" thick 1zz Flange same as supra. $75.00

One 2zz 1/2" thick flange $75.00

One 2zz 3/8" thick flange that has been used but has had the welds ground off. You'll need to spend a few minutes with a die grinder to make it fully usable, but you can save some money. $40.00

five GT28 outlet flanges. 1/2" thick $30.00 each.

four log manifold assemblies (see first picture) Not attached to the flange, but are welded up and ready for you to attach your turbo flange. $40.00 each, +$20 if you want me to bold the flange to the jig and weld it to a 1zz flange. Spacing isn't correct for the 2zz.

Two Tial WG flanges, non threaded, stainless steel. $25.00 each

Six Garrett GT series outlet flanges $35.00 each

five Toyota CT26 Flanges 25.00 each.

Four Schedule 10, 90 degree 1.5" bends (1/8" wall thickness) 8.00 each.

Eight Schedule 10 Tee bends for building a long manifold, 1/8" thick walls 20.00 each

Fifty Toyota O2 flanges without threads. 15.00 each, I'll thread the small holes for 8x1.25 threads and the big hole for an o2 sensor for an additional 10.00 (or 25 each)

Two T3 flanges 20.00 each.


Photos are here:
http://home.roadrunner.com/~brad.bedell/1zzflange.jpg
http://home.roadrunner.com/~brad.bedell/2zzflange.jpg
http://home.roadrunner.com/~brad.bedell/gt28flange.jpg
http://home.roadrunner.com/~brad.bedell/tial.jpg
http://home.roadrunner.com/~brad.bedell/gtflange.jpg
http://home.roadrunner.com/~brad.bedell/ct26.jpg
http://home.roadrunner.com/~brad.bedell/bends.jpg
http://home.roadrunner.com/~brad.bedell/o2flange.jpg
http://home.roadrunner.com/~brad.bedell/t3flange.jpg


I'll have other flanges listed up as soon as I figure out which ones that I wish to sell.

A box, packing material, tape, ink & paper for a label and fuel to deliver these items to the shipping depot is $10.00 per item and will go up a $1-3.00 per item if you want multiple items. Outside of the US is more.

These items are still available if they are listed up here.


IF you want any of these, email me. I'm very likely to not respond to a PM and I am not subscribed to this thread. Hit the Email member button or otherwise type in: bradmr2 at hotmail.com