91 ECU pinout/safc install

killermillermr2 · 10-17-2009, 01:31 AM

I am trying to wire in an safc2 to my 5sfte. The problem is that the diagram I have for the pins doesnt seem to match up to the plugs. I am looking at page FI-52 of the BGB. But the unused pins on the 14p plug are in the wrong spot, and where the PIM is supposed to be, the wire is not the same color as any on the MAP plug. Any thoughts? I can take pictures of anything if necessary.

One more thing, when comparing the diagram to the plug, do you look at the plug from the wire side or the pin side. I know this is a stupid question, but I want to be certain about this and I am an electrical idiot.

killermillermr2 · 10-17-2009, 01:03 PM

so far I have been informed the center pin in the MAP plug is PIM. can anyone tell me which wire is IGT in the ingniter plug, and how to check which is +B(EFI main relay{12v power}) and EO1(power gound). I am not positive on how to properly check continuity of +B and EO1.

Please help the electronic ignorant. I need to get this done so I can get to work Monday

10-17-2009, 01:31 AM	#1 (permalink)
killermillermr2 Honda Hunter Join Date: Dec 2007 Location: Colorado Posts: 864 Thanks: 25 Thanked 28 Times in 28 Posts iTrader Rating: (10/100% )	91 ECU pinout/safc install I am trying to wire in an safc2 to my 5sfte. The problem is that the diagram I have for the pins doesnt seem to match up to the plugs. I am looking at page FI-52 of the BGB. But the unused pins on the 14p plug are in the wrong spot, and where the PIM is supposed to be, the wire is not the same color as any on the MAP plug. Any thoughts? I can take pictures of anything if necessary. One more thing, when comparing the diagram to the plug, do you look at the plug from the wire side or the pin side. I know this is a stupid question, but I want to be certain about this and I am an electrical idiot.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

10-17-2009, 01:03 PM	#2 (permalink)
killermillermr2 Honda Hunter Join Date: Dec 2007 Location: Colorado Posts: 864 Thanks: 25 Thanked 28 Times in 28 Posts iTrader Rating: (10/100% )	so far I have been informed the center pin in the MAP plug is PIM. can anyone tell me which wire is IGT in the ingniter plug, and how to check which is +B(EFI main relay{12v power}) and EO1(power gound). I am not positive on how to properly check continuity of +B and EO1. Please help the electronic ignorant. I need to get this done so I can get to work Monday