Swap Near completion, But how do I...

Jay-Spec · 07-22-2006, 03:35 PM

I am near the completion of my auto/manuel swap, but i have a small problem, which is how do i clip trhe axles back in. Splines line up fine, but iam having a hard time clipping them back in, I tried a hammer but no luck.

Raptor13x · 07-22-2006, 09:59 PM

First of all, make sure you apply some grease to them before throwing them back in. Other than that, it just requires a little force. A hammer is a bad idea, just grab ahold and give it a quick yank in, and it should go without much trouble.

07-22-2006, 03:35 PM	#1 (permalink)
Jay-Spec No Skills Join Date: Apr 2006 Location: Chicago Posts: 24 Thanks: 0 Thanked 0 Times in 0 Posts iTrader Rating: (0/0% )	Swap Near completion, But how do I... I am near the completion of my auto/manuel swap, but i have a small problem, which is how do i clip trhe axles back in. Splines line up fine, but iam having a hard time clipping them back in, I tried a hammer but no luck.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

07-22-2006, 09:59 PM	#2 (permalink)
Raptor13x Legendary Join Date: Apr 2006 Location: Farmington Hills, MI Posts: 3,997 Thanks: 7 Thanked 44 Times in 37 Posts My Google Map iTrader Rating: (5/100% )	First of all, make sure you apply some grease to them before throwing them back in. Other than that, it just requires a little force. A hammer is a bad idea, just grab ahold and give it a quick yank in, and it should go without much trouble.