lower arm bar

[Dillyumpshous]

do they make a lower arm bar for a mk2? if so, where can i get one.

[TomsMR2]

a what?

[Dillyumpshous]

like a tie bar... its for the rear.

[TomsMR2]

its not a honda. we dont have that kind of suspension.

[Mister2.2]

Tein makes one: http://www.tein.com/okuyama_LAB.html

So does Jic: http://www.jic-magic.com/ViewProduct.aspx?ProductID=15

[MR2azzkicker]

Originally Posted by Mister2.2

Tein makes one: http://www.tein.com/okuyama_LAB.html

So does Jic: http://www.jic-magic.com/ViewProduct.aspx?ProductID=15

those are both for the front. i know the JIC one is because i am running it. i dont think any one makes one for the rear. why would they? we have a big ass cross member tieing everything together. adding one of these would do nothing.

v/r,
steven

[TomsMR2]

some cars have rear bars that tie the suspensions together.. we cant use that kind of bar.

[Dillyumpshous]

i seen the jic. i might get it but this torque bar is comming out soon. i think im gonna get this first.
http://www.twosrus.com/catalog/produ...01026b67050120

[MR2azzkicker]

Originally Posted by Dillyumpshous

i seen the jic. i might get it but this torque bar is comming out soon. i think im gonna get this first.
http://www.twosrus.com/catalog/produ...01026b67050120

that has been out forever, i still have one sitting in the garage. you do know this performs an entirely different task than what your original question asked, right? if you are going that route, i would check into the silk road one, it is isnt quite as beefy but does the same job so it will save you a few pounds. the silk road is only for the gen III though.

v/r, steven