Search:

Ya, cause it *should* mean the solenoid is working.

Just make sure both the battery terminal and the wire to it are cleaned, and then check to make sure the tranny ground is cleaned as well.
...

i had the same problem and came to found out it was a badground so i ran a ground wire from my bolt on my starter to my frame and it starts everytime if i were you i would try it make sure it is 220...

9 out of 10 times if the starter just does a loud click it's usually a bad connection , the most common being the ground but you might as well check your positive too.

Drain plugs tight? Simple to check, I had loose ones once, was a 2 minute fix and a 20 minute cleanup lol.

If anything it is normal.

I use one of those tranny jack from harbor freight, cost about 50-60 bucks, the kind that you put a 1/2 drive rachet at the end to raise and low, works great, but then again, I only needed it because...

first put your car on four jack stands then get 2 floor jacks , place 1 under the oil pan with a block of wood so it doesn't damage the oil pan and the other jack under the tranny. disconnect the...

I have never used an alignment tool for the 4age. I don't even know if it is specifically special but I have always eyed it real well then put the box on. Cleaning the housing helps in finding where...

To make sure it is disengaging have the car stopped and turned off on a nice level piece of ground and push in the clutch (in first of coarse). Crank the car over and their should be no movement at...

1. there are two screws on the inside (one at each end if i recall). You then have to pull up from the ends to pull off the plastic clips that hold it on the door.
2. Pretty self evident once you...

mine squeaked, I tightened it and it helped a lot.... but I replace my alternator and replaced both my AC belt and my alt belt.... both had excessive cracking/chunks missing in the grooves.

Don't buy a belt tension gauge. A good way to test belt tension is to compare it to another car. Feel the way a belt feels on a new car, and feel the way the belt feels on yours. If it is water...

Probably right :)



Yes, it could.



A glazed belt is a true explanation. Glazing can be caused by a loose belt - think of the belt slipping a little bit as it goes around the pulleys. When...