How bad is this?

Trak Turtle · 10-31-2009, 04:01 AM

My ABS light was always on since I bought the car & my rear sensor showed up bad. It also showed damage to the tip so I knew I'd find my rotor in a no better condition.
I figured this is end of the road for this rotor... what are my options from here guys? My drive shaft is in great condition & I'm fearing the road ends for my shaft too If I need to get my ABS up again.

Someone please tell me there's a solution other than a whole new shaft!

Trak Turtle · 11-01-2009, 02:17 PM

Anyone pls guys? Do I need to buy a new shaft?

da_force · 11-01-2009, 03:15 PM

Not complete shaft

That whole part comes off, you need to take off the "rubber" (I don't know the english expresion lol ), check is there some kind of security, to keep it from not falling off, after that if it is free, give it a couple of hits with a hammer (but not directly with a hammer use a piece of wood or something in betwen) and it will come off...buy a new one, put the rubber back on with some "grease",then the new part... and that would be it..

Trak Turtle · 11-02-2009, 11:27 AM

Ok Force... this is how its been so far

-
MR2 Owners Club Message Board&#8482

da_force · 11-05-2009, 07:38 AM

Ah it comes off separete

even better

well god thing you checked there... I don't have abs on mine, and have never in my life met a problem of destroyed rings... only changing that part of the axle ..

gl with finding new ring

MR JAS · 11-05-2009, 04:50 PM

yea just a new outer cv joint and boot not to hard or expensive to fix

Trak Turtle · 11-17-2009, 10:19 AM

10-31-2009, 04:01 AM	#1 (permalink)
Trak Turtle Cage Fighter Join Date: Mar 2009 Location: Gurgaon, India Posts: 151 Thanks: 7 Thanked 0 Times in 0 Posts iTrader Rating: (2/100% )	My ABS light was always on since I bought the car & my rear sensor showed up bad. It also showed damage to the tip so I knew I'd find my rotor in a no better condition. I figured this is end of the road for this rotor... what are my options from here guys? My drive shaft is in great condition & I'm fearing the road ends for my shaft too If I need to get my ABS up again. Someone please tell me there's a solution other than a whole new shaft! Last edited by Trak Turtle; 11-01-2009 at 09:18 AM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

11-01-2009, 02:17 PM	#2 (permalink)
Trak Turtle Cage Fighter Join Date: Mar 2009 Location: Gurgaon, India Posts: 151 Thanks: 7 Thanked 0 Times in 0 Posts iTrader Rating: (2/100% )	Anyone pls guys? Do I need to buy a new shaft?

11-01-2009, 03:15 PM	#3 (permalink)
da_force Some Skills Join Date: May 2009 Location: Croatia, Zagreb Posts: 63 Thanks: 1 Thanked 1 Time in 1 Post iTrader Rating: (0/0% )	Not complete shaft That whole part comes off, you need to take off the "rubber" (I don't know the english expresion lol ), check is there some kind of security, to keep it from not falling off, after that if it is free, give it a couple of hits with a hammer (but not directly with a hammer use a piece of wood or something in betwen) and it will come off...buy a new one, put the rubber back on with some "grease",then the new part... and that would be it..

11-02-2009, 11:27 AM	#4 (permalink)
Trak Turtle Cage Fighter Join Date: Mar 2009 Location: Gurgaon, India Posts: 151 Thanks: 7 Thanked 0 Times in 0 Posts iTrader Rating: (2/100% )	Ok Force... this is how its been so far - MR2 Owners Club Message Board&#8482

11-05-2009, 07:38 AM	#5 (permalink)
da_force Some Skills Join Date: May 2009 Location: Croatia, Zagreb Posts: 63 Thanks: 1 Thanked 1 Time in 1 Post iTrader Rating: (0/0% )	Ah it comes off separete even better well god thing you checked there... I don't have abs on mine, and have never in my life met a problem of destroyed rings... only changing that part of the axle .. gl with finding new ring

11-05-2009, 04:50 PM	#6 (permalink)
MR JAS alfa 155 v6 manual>>> mr2 Join Date: Apr 2009 Location: hamilton new zealand Posts: 358 Thanks: 7 Thanked 9 Times in 8 Posts iTrader Rating: (0/0% )	yea just a new outer cv joint and boot not to hard or expensive to fix

11-17-2009, 10:19 AM	#7 (permalink)
Trak Turtle Cage Fighter Join Date: Mar 2009 Location: Gurgaon, India Posts: 151 Thanks: 7 Thanked 0 Times in 0 Posts iTrader Rating: (2/100% )